Degree of gloss (at measurement angle 60° acc. to DIN 67530):
satin matt: 40-50 gloss units
80 - 90 gloss units after coating with MoTip Rallye Clear Coat glossy
Depending on consistence and color of the ground:
150 ml are sufficient for 1 rims
500 ml are sufficient for 4-5 rims
Drying time (at 20°C, 50% relative air humidity):
Dust-dry: after approx. 5-10 minutes
Tack-free: after approx. 10-20 minutes
Cured: after 24 hours
Coatable with clear lacquer: after approx. 2 hours
The drying time depends on surrounding temperature, air humidity and thickness of the applied coat.
Temperature-resistant: up to 110°C
10 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
aerosol cans with maximum nominal volume 150 ml resp. 500 ml
Before use, carefully read and observe the warning texts on the label!
Preparation of the ground:
Carefully clean rims from dirt, fat and brake-dust.
Treat existing pore rust with presto Deruster.
The ground has to be sanded, clean, dry and fat-free.
Mask off the rim edges with masking tape.
Use paper to protect surrounding area from spray-dust.
Prime with CAR's Primer.
After drying, slightly sand (sanding paper grain P600).
The surface has to be clean, dry and free from rust and fat.
Before use, shake the can vigorously for 2 minutes.
Test spray to check colour-matching.
Spray several thin coats in 3 - 5 minute intervals from a distance of approx. 25 cm.
After 60 minutes drying time, coat with MoTip Rallye Clear Varnish to protect the metal pigments in the lacquer.