MP Tape 80° - Top quality
ColorMatic plastic adhesive is applied directly as a primer and sticks very well on all plastic interior and exterior car parts, including bumpers, mirrors and tuning parts. It can be painted over after drying for about 10 minutes with, for example, ColorMatic 1K primer filler, plastic paint or pre-fill base coat.
The ColorMatic plastic adhesive is suitable for most car and lorry interior and exterior plastic parts.
QUALITY AND PROPERTIES
Environmentally sound: The products of MOTIP DUPLI are 100% free of heavy metals. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by MOTIP DUPLI comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Before use, carefully read and observe the warning texts on the label!
2K extra fine polyester stopper / filler for minor imperfections on surfaces. Ensures a smooth surface and a perfect feather edge. Easy to sand with P150 - P400 grit paper to obtain a perfect pinhole free finish. Also suitable for plastic bumper repairs
High-glossy effect spray that gives a look similar to chrome to smooth surfaces. Suitable for all smooth surfaces, especially for designing rims, wheel trims, coatable plastic parts if appropriately primed.
With this product MOTIP DUPLI for the first time offers a chrome spray which is resistant to abrasion and to weathering.
An optimal effect will be achieved on a black surface, e.g. by pre-coating with MoTip Tuning Effect Primer.
The set contains:
1 x 150ml aerosol Effect primer black
1 x aerosol SILVER CHROME 400ml
If the surface is not varnished so do not treat with any polish !
The picture is just ilustrative, the products are available as single items
One component fine filler, ideal for filling pinholes and finishing small uneven surfaces. Apply 2-3 light coats with a flash-off time and allow 30 minutes of drying. Can be easily sanded with P600-P1000 grit paper. Can be overcoated with all type of primers or paint systems.