ColorMatic plastic adhesive is applied directly as a primer and sticks very well on all plastic interior and exterior car parts, including bumpers, mirrors and tuning parts. It can be painted over after drying for about 10 minutes with, for example, ColorMatic 1K primer filler, plastic paint or pre-fill base coat.
The ColorMatic plastic adhesive is suitable for most car and lorry interior and exterior plastic parts.
QUALITY AND PROPERTIES
Easy and fast application
Very good adhesion to most plastic car parts such as bumpers, tuning parts, mirrors
Very fast drying time
Can be directly painted over with 1K and 2K ColorMatic primer filler, RAL-acrylic topcoat and pre-fill base paints
PHYSICAL AND CHEMICAL DATA
Basis of the binder: Polyolefin resin
150 ml are sufficient for approx. 2 m²
10 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
Aerosol cand, maximum nominal volume 400 ml
400 ml = 276,4 g
150 ml = 111,0 g
ENVIRONMENT AND LABELLING
Environmentally sound: The products of MOTIP DUPLI are 100% free of heavy metals. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by MOTIP DUPLI comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Before use, carefully read and observe the warning texts on the label!
ColorMatic 2K clear coat is a high-gloss, extremely scratch-resistant 2-component clear coat with very high resistance to petrol, UV rays and weathering. Due to its quick drying time, very good flow and easy polishing, ColorMatic 2K clear coat is particularly suitable for spot repairs. Use ColorMatic spot blender for spot repairs. Ready-filled ColorMatic pre-fill products can be recoated after 30-minute drying time. Previous paintwork has to be fully dry.
Application: Ideal for spot repairs and refinishing parts
Quality and properties
High-gloss, extremely scratch-resistant 2-component clear coat with very high resistance to petrol, UV rays and weathering
Long pot life
Fast drying time
Very good flow
Easy to polish
Best to use 200 ml can to avoid surplus
Physical and chemical data
Basis of binder: Acrylic
Degree of gloss: (at measurement angle 60° acc. to DIN 67530?
glossy: 85 gloss-units
Depending on consistence and colour of the ground:
200 ml are sufficient for approx. 0,3 - 0,4 m²
500 ml are sufficient for approx. 0,8 - 1,0 m²
solvent- and water-based base coats
Drying time (at 20°C, 50% relative air humidity):
Dust-dry: after approx. 5 minutes
Dry to touch: after approx. 5 hours
The drying time depends on surrounding temperature, air humidity and thickness of the applied coat.
Temperature resistance: to 120°C
36 month if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
2 components aerosol cans, maximum nominal volume 200 and 500 ml
24 hours at room temperature (20 - 25°C)
5 days at cool storage (6°C)
Befor using again warm up to room temperature (20 - 25°C).
See using instruction.