By using MP Polilisching sponge UNI in conjunction with the unique polishing agent OneStep-SuperPolish, it is not only possible to polish the work on trapped dust insertions shortly after the coating but also to remove scratches in one process.
- universal 25 mm polishing sponge for the polishing of
Degree of gloss (at measurement angle 60° acc. to DIN 67530):
glossy: 90 gloss units
Depending on consistence and color of the ground:
12 ml for small spots Drying time (at 20°C, 50% relative air humidity):
Dust-dry: after approx. 15 minutes
Dry to touch: after approx. 60 minutes
Dust-dry: after approx. 5-10 minutes
Tack-free: after approx. 10-20 minutes
Coatable: after approx. 2 hours
The drying time depends on surrounding temperature, air humidity and thickness of the applied coat.
Temperature-resistant: up to 110°C
touch-up pencil: 5 years, aerosol can: 10 years, if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
Environmentally sound: The products of MOTIP DUPLI are 100% free of heavy metals. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by MOTIP DUPLI comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
The most presto spray paints have a so-called no-spray ring or a tamper-proof cap. This is to avoid unauthorized use. Please see the corresponding advises on the cap or on the label. Before use, carefully read and observe the warning texts on the labels!
Erase with the 2 mm above grinding lead under slight pressure.
Do not push the lead more than 2 mm out of the housing.
The fiberglass lead sharpens itself automatically and allows precise work.
Is the part of the outstanding lead used, place the mine a step forward in the thread.
Therefore pull the gray cap forward and open the housing.
Is the lead totally used up, just replace it with a included replacement lead.